Band Saw

JET JRF-14 708718 Rip Fence ✚ Feedback by : hangtree

Jet Bandsaw Rip Fence an OK 5 stars ✚ Feedback by : BGeorge

jet rip fence ✚ Feedback by : Michael Moore

does it's job ✚ Feedback by : D. Millman

Great fence for the price! ✚ Feedback by : B. Robson

Review by hangtree

Acquired a Ridgid 14" band saw but Ridgid quit offering the rip fence for it. Tried using a Craftsman, but located it to wobbly on the backside. Went for this Jet model and the rails suit appropriate into my predrilled table holes. Had to drill a hole about 1.5" back from the end on the underside of the fence to in shape my table and lock far more securily. Had it installed in about 20 minutes and it locks down restricted with no play. Also comes with a resaw block. .

I obtained this instead of the blue large value non-Jet design because it hooks at the back of the fence rail as nicely as on the front. Took about an hour to set up, the only hitch make confident the brace that holds the front rail on, is mounted on the front aspect of the table, not the back as the recommendations type of show. Its not whiz bang, gee golly but it works and its precise. .

very first impressions was a extremely wonderful and sturdy addition , but after utilizing for about a week it no lengthier would grip and hold in spot, it appears some thing was missing from the leaver where it grips to maintain the fence,have to phone jet when i remember, i did cure it momentary by inserting a pad in which i think there was one particular , works okay now but for how lengthy i do not know ,have to kind it cant perform devoid of the fence .

I acquired it, I place it on, it works and I have not assumed of it considering that. I have a number of months of use on it now and I am content that I purchased it. I never have yet another bandsaw rip fence to assess it to, but I never require nearly anything else. .

I installed this fence on my RIDGID 14" bandsaw. It went on with no difficulties despite the fact that I also had to drill a hole in the bottom of the fence about an inch back again from the factory hole which mounts the rear rail slider. Not a massive offer, it is made for a Jet after all, which apparently has a a bit lengthier table than the RIDGID.Soon after putting it all jointly, I had it all squared up in a matter of a handful of minutes. The adjustments are quite simple, mainly just tilting the rails a bit right up until the f